Single Phase - Dry Run with Timer

This starter is built to protect your pump motor from two of the most common causes of damage: running dry and drawing too much current.

Dry-run protection detects when your pump has no water to draw and shuts the motor off automatically, before it can damage itself running empty. If you're using this for a motor other than a water pump, a side switch lets you bypass dry-run detection entirely. Overload protection is set automatically — the first time you install the panel, just hold the "Push to Set" button for 2 seconds, and it detects and sets the right trip current for your motor on its own, no manual adjustment needed.

A digital display shows the motor's running current by default, with a separate button to check the incoming voltage whenever you need it. Indicator lights for Motor On, Overload, and Dry Run keep you informed of exactly what's happening at a glance.

With the Up/Down buttons, you can also set a running duration — anywhere up to 5 hours, adjustable in minutes — and once that time is up, the motor switches off on its own. Your last timer setting stays saved, so you don't have to set it again every time you start the motor. Starting is a simple push-and-hold, and a dedicated Stop button gives you an instant, deliberate way to cut power.

Everything sits inside a solid, powder-coated metal body built for daily use.